This will reduce the steps in case the redesign of a component within the pattern is needed. It is recommended that several patterns are used and create each header of the components individually.Īfter having all the headers added, combine them to have the finalized pattern. Steps Pattern Editor: Open DipTrace and choose the Pattern Editor option as shown in Figure 1to open the pattern editor session of DipTrace.įigure 1: Open Patter Editor The first step to the design is to create one of the hardware pattern headers.
The communication between the PSoC and Arduino Shield will transpire without further hardware interaction.Īfter the two components are added to the PCB the only changes needed for flexibility in application will be based on software design instead of hardware. This final product includes the PSoC, the Arduino Shield and the PCB. Objective The objective of this manuscript is to create the libraries and schematics for the PCB that will hold and interface the PSoC First Touch Kit and Arduino Shield. There are some references and appendix information at the end of this document that can help if further assistance is needed with the techniques not focused on in this paper. Throughout this paper there is the assumption that the components layout have already been created and that the user is familiar with the procedure. The four steps needed are Component design, Pattern Library design, Schematics Layout and the PCB layout. These are two of the four steps needed to create a PCB design using this software. This document will walk the user through creating and using pattern libraries and schematics layouts in DipTrace. Keywords DipTrace, Pattern Libraries, Schematic Layout, PCB Design, PCB Introduction DipTrace is a software application for creating schematics and printed circuit boards (PCB) 1. These are two key steps needed in the design of the PCB that will hold the PSOC First Touch Kit and the Arduino Ethernet Shield.Īt the end of the design the user will be ready to layout the PCB for fabrication.
To name each header component use the Pattern Property window displayed in the upper right hand side corner of the screen. These executables are provided pre-compiled for all platforms OS officially supported by Yoctopuce. Those files are quite big because they include a lot of pre-compiled examples with source files. Some languages, such as Javascript and PHP, also require the Virtual Hub software. There is one library per language, which can control all available modules.
8.In the MegaPi firmware, SLOT1 is changed to slotnum instead of parameter transmission in the command processing stepper motor.
0 kommentar(er)
